
Tony Watts on Seamounts and the Strength of the Lithosphere
05/12/22 • 28 min
When plate tectonics was adopted in the 1960s and early '70s, researchers quickly mapped out plate movements. It seemed that plates moved as rigid caps about a pole on the Earth's surface. But since then, a lot of evidence has accumulated suggesting that plates are not, in fact, totally rigid. In fact, we can see them flex in response to stresses that are imposed on them. Such stresses can arise on plate boundaries, such as when two plates collide and one plate flexes down to subduct under the other. For example, we see a flexural bulge in Northern India where the Indian plate bends down under the Eurasian plate. Similar bulges are seen at subduction zones where the oceanic lithosphere flexes up before it bends down into a trench, such as off the eastern coast of Japan. Stresses can also be imposed in plate interiors when the plate is subjected to a load, such as a volcano or a sedimentary basin. An example of sediment loading occurs in river deltas, such as that of the Ganges in the Bay of Bengal.
Our guest today pioneered an ingenious method of determining the flexural strength of oceanic plates. The method uses the flexural sag of plates in response to the weight of seamounts, most of which were emplaced on their surfaces by mid-ocean eruptions. His results suggest that less than half of an oceanic plate actually contributes to its elastic strength. The rest is brittle (top layer) or ductile on the relevant time scales (bottom layer).Tony Watts is Professor of Marine Geology and Geophysics at the University of Oxford and a Fellow of the Royal Society.
If you like Geology Bites, please rate and review the podcast. It helps others find it.
When plate tectonics was adopted in the 1960s and early '70s, researchers quickly mapped out plate movements. It seemed that plates moved as rigid caps about a pole on the Earth's surface. But since then, a lot of evidence has accumulated suggesting that plates are not, in fact, totally rigid. In fact, we can see them flex in response to stresses that are imposed on them. Such stresses can arise on plate boundaries, such as when two plates collide and one plate flexes down to subduct under the other. For example, we see a flexural bulge in Northern India where the Indian plate bends down under the Eurasian plate. Similar bulges are seen at subduction zones where the oceanic lithosphere flexes up before it bends down into a trench, such as off the eastern coast of Japan. Stresses can also be imposed in plate interiors when the plate is subjected to a load, such as a volcano or a sedimentary basin. An example of sediment loading occurs in river deltas, such as that of the Ganges in the Bay of Bengal.
Our guest today pioneered an ingenious method of determining the flexural strength of oceanic plates. The method uses the flexural sag of plates in response to the weight of seamounts, most of which were emplaced on their surfaces by mid-ocean eruptions. His results suggest that less than half of an oceanic plate actually contributes to its elastic strength. The rest is brittle (top layer) or ductile on the relevant time scales (bottom layer).Tony Watts is Professor of Marine Geology and Geophysics at the University of Oxford and a Fellow of the Royal Society.
If you like Geology Bites, please rate and review the podcast. It helps others find it.
Previous Episode

Neil Davies on the Greening of the Continents
Life only emerged from water in the Ordovician. By that time, life had been thriving in oceans and lakes for billions of years. What did the colonization of the land look like, and how did it reshape the Earth’s surface? Neil Davies describes how we can decipher the stratigraphic sedimentary record to address these questions. Perhaps surprisingly, it’s easier to recognize small and fleeting events than to recognize large-scale features such as mountains, valleys, and floodplains. He also describes his remarkable 2018 discovery of the largest known arthropod in Earth history — a 2.6-meter-long millipede.
Neil Davies is a Lecturer in Sedimentary Geology at the University of Cambridge. He studies the interconnections and feedback loops between life and sedimentation. His research aims to understand how such interactions manifest themselves in the rock record. He does this by combining analyses of sedimentary structures and textures, stratigraphy, and trace fossils.
Next Episode

Phil Renforth on Carbon Sequestration
For many years, efforts to limit climate change have focused on curtailing anthropogenic emissions of greenhouse gases. But it is increasingly clear that such curtailment will not, on its own, be able to prevent the damaging effects of global warming. Therefore, more attention is now directed to mitigating climate change by enhancing the removal or sequestration of greenhouse gases from the atmosphere. As a result, our climate change goals are now often specified in terms of when we plan to reach net zero emissions rather than on when we can just reach emission reduction targets.
Phil Renforth is an expert on carbon sequestration. He is especially interested in enhancing the weathering of rocks and has performed in-depth investigations of geochemical techniques of removing atmospheric carbon dioxide. He is an Associate Professor in the School of Engineering and Physical Sciences at Herriot-Watt University.
There are illustrations supporting this episode at geologybites.com.
If you like this episode you’ll love
Episode Comments
Generate a badge
Get a badge for your website that links back to this episode
<a href="https://goodpods.com/podcasts/geology-bites-398059/tony-watts-on-seamounts-and-the-strength-of-the-lithosphere-39606102"> <img src="https://storage.googleapis.com/goodpods-images-bucket/badges/generic-badge-1.svg" alt="listen to tony watts on seamounts and the strength of the lithosphere on goodpods" style="width: 225px" /> </a>
Copy